|
|||||||||
|
|||||||||
|
|
|||||||||
 |
|||||||||
|
9. The swing arm can now be
pulled from the frame. |
|||||||||
 |
|||||||||
|
10.
Here we get a good look at the new swing arm bracket. The difference
in height is due to the offset built into the new swing arm. |
|||||||||
 |
|||||||||
|
11. When the new swing arm
bracket is installed, it is vital that the attached roll pin... |
|||||||||
 |
|||||||||
|
12. ..line up with the
corresponding pin hole in the rubber mount. |
|||||||||
 |
|||||||||
|
13. Install the pivot shaft
along with all the washers, the rubber mounts, the cleveblocks, and the
spacers. Since the shaft goes through the mounting brackets as well
as the transmission and the swing arm take care in lining everything up
where the shaft is installed. This is the reason why in step 6 we
did not tighten the stabilizing links. |
|||||||||
 |
|||||||||
|
14. Here we get a good look at the difference between the stock swing arm and our new piece. |
|||||||||